200-105 Exam PDF Questions
Question No. 1
Which three describe the reasons large OSPF networks use a hierarchical design? (Choose three.)
Question No. 2
What are three advantages of vlans? (Choose three.)
Question No. 3
Which result occurs when you configure the switchport mode dynamic auto command on the switch ports at
both ends of a trunk link?
Question No. 4
Which component of the Cisco SDN solution serves as the centralized management system?
Cisco ACI is a comprehensive SDN architecture. This policy-based automation solution supports a business-relevant application policy language, greater scalability through a distributed enforcement system, and greater network visibility. These benefits are achieved through the integration of physical and virtual environments under one policy model for networks, servers, storage, services, and security.
Question No. 5
Which command helps a network administrator to manage memory by displaying flash memory and NVRAM
Question No. 6
The network administrator of the Oregon router adds the following command to the router configuration: ip
route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command? (Choose two.)
Question No. 7
Which two commands debug a PPPoE connection that has failed to establish? (Choose two.)
Question No. 8
Which two EtherChannel PAgP modes can you configure? (Choose two.)
Question No. 9
To which two categories of routing protocols does BGP belong? (Choose two.)
Question No. 10
Refer to the exhibit.
Given the output shown from this Cisco Catalyst 2950, what is the reason that interface FastEthernet 0/10 is not the root port for VLAN 2?
These four parameters are examined in order to make root bridge , root port , designated port. Other switch has lowest Sending Bridge ID or Sending Port ID so vlan 2 is not the root port.
1. A lower Root Bridge ID
2. A lower path cost to the Root
3. A lower Sending Bridge ID
4. A lower Sending Port ID
Question No. 11
What is true about Ethernet? (Choose two.)
Question No. 12
Which command is necessary to permit SSH or Telnet access to a Cisco switch that is otherwise configured
for these vty line protocols?