EMC E20-307 VMAX Flash Exam Questions
EMC’s Implementation Engineer (EMCIE) certification as a profession has an incredible evolution over the last few years. EMC E20-307 VMAX Flash and VMAX3 Solutions Specialist for Implementation Engineer exam is the forerunner in validating credentials against. Here are updated EMC E20-307 exam questions, which will help you to test the quality features of DumpsSchool exam preparation material completely free. You can purchase the full product once you are satisfied with the product.
Please check the option that best describes your relationship with Dell EMC:
A. Dell EMC Employee
B. Dell EMC Customer/Partner
Please enter your Powerlink Username below. If you do not have a Powerlink Username or do not know your Powerlink Username enter none.
What are pre-configured in VMAX3 and VMAX All Flash arrays?
A. SRDF devices
B. Gatekeeper devices
C. Thin devices
D. Data devices
A TimeFinder SnapVX snapshot of source volumes has been linked to target volumes. The target volumes are being used for application testing. What should be done prior to a relink operation?
A. Continue accessing the source volumes, stop accessing the target volumes.
B. Continue accessing the source and target volumes.
C. Stop accessing the source and target volumes.
D. Stop accessing the source volumes, continue accessing the target volumes
A VMAX3 parent Storage Group (SG) contains two child SGs: SG1 and SG2. What is a valid bandwidth limit setting for this cascaded Storage Group?
A. Parent SG 400; SG1 500; SG 200
B. Parent SG 400; SG1 500; SG NOLIMIT
C. Parent SG 500; SG1 500; SG 400
D. Parent SG 500; SG1 NOLIMIT; SG 1000
At which levels are FAST performance metrics collected in a VMAX3 array?
A. Disk Group, Storage Group, and thin device sub-LUN
B. Data Pool, Storage Resource Pool, and Storage Group
C. Disk Group, Data Pool, and thin device sub-LUN
D. Disk, Data Pool, and Storage Resource Pool
What is the correct sequence of actions performed by a VMAX3 when the SRDF failback command is executed?
Which Solutions Enabler environment variable can be set to stop the user from getting asked for confirmation during command execution?
https://www.emc.com/collateral/TechnicalDocument/docu46983.pdf (page 243)